This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong. ====== RAK Client WiFi Setup ====== Follow these steps to configure the RAK router as a WiFi client. ===== 1. Power On and Connect ===== - Power on the router and wait for the LED to **pulse blue/green** (approx. 30s to 1min). - On your PC, check the list of available Wi-Fi networks: *If the RAK router appears, connect to it. *If it **does not appear**, refer to the [[#troubleshooting|Troubleshooting]] section. {{:technical_docs:loriot:amazon-1.png?400|}} - A password is required to connect. Most routers use the default password: ***MyFridgeRAK#1** * If not, refer to the **location sheet** for the correct password. ===== 2. Access the Router Console ===== - Open a browser and navigate to: **https://192.168.230.1/** - If you see a "Connection Not Private" warning: *Click **Advanced** {{:technical_docs:loriot:amazon-2.png?600|}} *Click **Proceed** {{:technical_docs:loriot:amazon-3.png?600|}} - At the login screen, use the **same password** found in the location sheet. {{:technical_docs:loriot:wifi-3.png?400|}} ===== 3. Enable Client WiFi Mode ===== - In the router console, navigate to **Network** on the left-hand menu. - Click the **WAN** tab. {{:technical_docs:loriot:loriot-6.png?200|}} - Open the **Wi-Fi** dropdown and click **Settings**. {{:technical_docs:loriot:wifi-5.png?600|}} > ⚠️ **Note:** During these steps, you may get disconnected multiple times. If the page doesn't load, make sure you’re still connected to the router’s network. - Toggle the Wi-Fi **Enabled** switch. {{:technical_docs:loriot:wifi-6.png?600|}} - The router will **restart** to apply the changes. - Reconnect to the router and return to the Wi-Fi settings (refresh the page if necessary). - Enter the Wi-Fi credentials for the **target network** and click **Save**. {{:technical_docs:loriot:wifi-7.png?600|}} ===== 4. Verify Connectivity ===== - Once connected, verify that the router is communicating with **Amazon** or **Loriot**. ===== 5. Troubleshooting ===== ==== RAK Not Showing in Wi-Fi List ==== This may indicate that Wi-Fi access is **disabled** on the device. Try the following steps to connect: - Connect a **LAN cable** directly between the router and a PC. - Power on the router. - Calculate the fallback IP using the router's MAC address. ==== Calculate the Fallback IP ==== Example: If the MAC address is `AC1F09140F01`: - Take the **last two hex digits**: `0F` and `01` - Convert them to **decimal** using Windows calculator: - `0F` → **15** - `01` → **1** {{:technical_docs:loriot:wifi-8.png?400|}} {{:technical_docs:loriot:wifi-9.png?400|}} - Construct the fallback IP as: **169.254.15.1** Use this IP in the browser to access the router console: - `https://169.254.15.1/` > After completing the setup, remember to **enable LAN WiFi** so the device appears again in the Wi-Fi list.